Pellicano Articles
Having a Xbox 360 system break on your could be truly annoying. The system will entirely shut down, not letting you access anything. At times, your discs will get stuck in the system too. If you send it in for repairs, you’ll finish up waiting quite a while to get the console back. Besides, they will charge you an arm-and-a-leg for repairs which they will not even warranty. If you train yourself to perform your own xBox 360 repair, however, you will be capable to immediately and proficiently solve any of the problems you come across.
The 3 Red Light Errors that rise whenever a Xbox is experiencing trouble are the last thing that anybody wishes to see. Luckily, a little over 90% of the problems which can happen to a Xbox 360 can be repaired by you. As long as you know what you are doing, Xbox 360 repair will be handled without any difficulty.
You must be able to get a booklet which can provide you thorough, step-by-step instructions which will assist you diagnose the problem. From there, a good guide will be able to tell you exactly how to solve these problems. Blindly poking around the equipment can just damage it even more. This is not something you must be doing.
It must be said, however, that if your Xbox 360 is still covered under guarantee, you should turn it in for official repair. The guarantee will cover and repairs which are needed and can restore your machine if the console is out of order. If you open the equipment, your warranty is considered broken and you will not be capable to get a replacement.
If using the guarantee is not an alternative, however, you must take matters into your own hands. Removing the protective casing is going to be the first step to repairing your Xbox 360. If you do not know how to properly open the console, you simply risk resulting into more damage.
Every system has a faceplate. This will be the first element which have to pop off as both of the top and the lower panels are attached to this. Pulling those off first can simply break the tabs keeping them in place. To remove the faceplate, all that you have to do is pop it out using the finger hole at the bottom of the panel.
The gray cover below will be the next to go. There are six tabs holding it into place which you can without any effort pop out. Utilizing the holes for the vents, you could use a device to push these tabs down while pulling lightly. This must pop every part out and allow you to open this panel.
Removing the upper cover will be a little more tough, even though it works in the same manner. The first two tabs will be accessed within the drive tray. The second two can be noticed within the vent holes on the top. You have to locate the last two tabs by opening the feet from the Xbox in the back. Once you have these panels off, however, you will be capable to begin your low-priced and effectual xbox 360 repair!
Tags: 3 red light errors, repair an xbox 360, repairing xbox 360, xbox 360 repair, xbox 360 repair guide
Posted in XBox · September 4th, 2010 · Comments (0)
No XBox 360 problems? Then count yourself as one of the lucky ones. With a malfunction rating of more then 50%, most consumers have undergone at least one problem with their system.
The problems range from disks being scratched, to “bricking”, or possibly perhaps the “Red Ring of Death”. Some issues like games freezing can be annoying, but most people often allow them.
Have you been playing your preferred game on your Xbox, and suddenly it freezes up on you? You reset the console to only realize that it freezes yet again. Taking out the disk you notice that there are now scratches on it. Unfortunately, this is typical with this console. As many as 1 in 9 consoles positioned flat, and 3 in 9 set on their sides have damaged disks. This is due mostly to two issues, a pad lost near the reader inside the the disk drive, or the drive not securing the disk in place before playing.
Another issue Xbox 360’s have is “bricking”. “Bricking” is a term used within the industry due to the brick form of most electronics. Since a brick is ineffective when it comes to gadgets, when items like a game console, DVD player or equivalent quits, it’s now “useless as a brick”. Some dashboard updates have caused “bricking”. The only solution for this is to check with Microsoft to see about a replacement or repair your Xbox 360. If the console is no longer in warranty, the repair could cost anywhere from $99 and up.
The common problem with Xbox 360’s is the “Red Ring of Death”. The name for this issue is derived from the three red lights that are on around the power light in the front of the console, forming a red ring. This is caused from either a general hardware crash or a core digital failure. Either of these issues is not good. Both call for your console to be sent in to Microsoft for repair or replacement. The average turn around to receive one after fix is eight weeks. Due to the frequency of this issue, Microsoft elongated the 1-year warranty that these consoles came with to 3 years from date of purchase.
Because of the frequency of failures of the Xbox 360, there were several lawsuits submitted. The first was immediately after the release of the console. Second was filed in November of 2006, only about a year after release. This lawsuit was due to the “bricking” that was encountered after the November 1, 2006 release of a dashboard patch.
The most recent class action lawsuit made against Microsoft was in October of 2008 by Californian consumers. The filers claim that Microsoft knowingly made faulty consoles and that they refused to release the actual failure numbers of the consoles.
Xbox 360’s too often have troubles. In an industry where only 3-5% is an accepted failure rating, a rating of over 50% is exorbitant! What happened to the game consoles that lasted for years and years without any problems what so ever?
Tags: issue Xbox 360, problem with Xbox 360, repair your Xbox 360, three red lights, xbox 360 problems
Posted in XBox · August 27th, 2010 · Comments (0)